Harley-Davidson Road King Handlebar Removal and Installation Manual
download If the wire length appears to be too short, you will have to lengthen the wires. If that’s the case, I must stress that soldering your wires is far superior to using butt splices. Wiring can...
View Article1982-2005 Harley Motorcycle Removal and Installation Instructions
download ” bolt from the mounting stem on the Signal® mirror. While seated on the motorcycle, position the Signal® mirror on the handle bar. Secure the Signal® mirror to the handle bar using the 5/ 16...
View ArticleHarley Davidson Speedo Healer Installation Manual
download a) Locate the three wire Deutsche connector that is situated behind the left hand side panel as viewed from the rear of the bike. This is normally grey in colour, and the wires are coloured...
View ArticleHarley-Davidson Electronic Ignition Module Installation instructions
download Step 1: Switch main dashboard switch to “off” position (Ignition& light switch) Step 2: Disconnect negative (ground) cable from the Battery Step 3: Remove the Condenser and Breaker points...
View ArticleBMW R1200GS Dual Function LED Running Lights and Flashing Brake Lights...
download The flasher is set to flash continuously as long as the brake is applied. To convert to a 5 second flash and then stay solid while the brake is applied, cut the green wire loop on the flasher....
View ArticleHARLEY DAVIDSON VRSC BRACKET FOR BILLET HEADLAMP SHELL REMOVAL AND...
download REMOVAL VRSCA Models 1. Remove windshield (if equipped). Refer to appropriate Instruction Sheet for procedures. 2. Remove right side cover and maxi-fuse. Refer to MAXI- FUSE in Service Manual....
View ArticleHARLEY DAVIDSON WIRE LOOM AND HORNS INSTALLATION INSTRUCTIONS
download Remove the stock horn and bracket from the stud it is mounted to and unplug the 2 wires. Remove the seat. Route the end of the wire and hose loom without the connectors. Starting in front of...
View ArticleHARLEY-DAVIDSON LARGE LED SILVER BULLETS INSTALLATION INSTRUCTIONS
download PROCEDURE STEP 1*Remove the stock turn signal fixtures and cut the wires in a convenient and inconspicuous splice location. STEP 2**Place the split lock and flat washers on to the hollow bolts...
View ArticleSR-C400 Motorcycle Security System INSTALLATION MANUAL AND USER'S GUIDE
download Routing the Antenna Wire The MCM includes an 18″ antenna wire. The first 12″ is a coaxial wire; the remaining 6″ is the reception antenna wire. When routing, try to avoid running the antenna...
View ArticleHARLEY DAVIDSON DETACHABLE QUARTER FAIRING AND DOCKING HARDWARE KIT...
download Installation The rider’s safety depends upon the correct installation of this kit. Use the appropriate service manual procedures. If the procedure is not within your capabilities or you do not...
View Article